求翻译：用测量治具对#2号绞孔机绞刀外径进行检验,有发现#2号绞孔机绞刀外径偏下限(实际测量的外径为￠8.9mm),所以对刀座进行绞孔后,会使得到的刀座孔径偏小.当合铜(￠9.0mm~￠9.03mm)与孔径偏小的刀座装备时,会导致过盈配合偏大, 从而可能导致刀座开裂. (备注: 实际上,#2号绞孔机在2012年初就被我司停止使用)是什么意思？

# 2 reaming machine reamer diameter measurement fixture inspection found # 2 reaming machine reamer diameter partial lower limit (the actual measured outside diameter ¢ 8.9mm), twist the knife block. hole, make the tool holder aperture is too small when copper (¢ 9.0mm ~ ¢ 9.03mm) aperture small kni

Use measurement tools to #2, the way Jack Knife Twisted Pair od examinations, it is found that the holes #2, the twisted pair knife outside diameter to limit (the actual measurement of the outside diameter of 8.9 mm ¢), so the knife after the hole, and a way to get the bore of a small knife, with co

正在翻译，请等待...

With measurement treatment with on #2, stranded hole machine Auger od for test, has found #2, stranded hole machine Auger od partial lower (actual measurement of od for DIA 8.9mm), so on knife seat for stranded hole Hou, will makes are of knife seat aperture partial small. Dang-in copper (DIA 9.0mm~

With surveys the fixture to ream the machine reamer outer diameter to the #2 number to carry on the examination, has discovered the #2 number reams the machine reamer outer diameter leaning lower limit (actual survey outer diameter is 8.9mm), therefore carries on after the tool apron reams, can caus