求翻译：如用22.5mm的销子去检验单个孔,孔径最小为22.6mm,在这种情况下再用上图的检验工装去检测产品,不考虑另外情况按理论计算四个孔的孔距公差有二种可能:①孔直径为22.6mm,四个孔的孔距为0公差。②孔直径为23mm,四个孔的孔距为±0.15公差。按照这个公差铸造无法达到要求。是什么意思？

With 22.5mm of the pin to test a single hole, the aperture is 22.6mm, and then on the test tooling in this case to detect the product, without considering the other theoretical calculations on a four-hole pitch tolerance The two kinds may be: ① hole diameter of 22.6mm, the pitch of the four holes fo

If you use the 22.5 mm pin to verify a single hole, the smallest aperture to 22.6 mm, and in this case with the figure of the test to detect the product, and not taking into account the situation by theoretical calculations of the 4 holes with 2 hole spacing tolerance of May: 1 hole diameter is 22.6

If examines the single hole with the 22.5mm pin, the aperture most is small is 22.6mm, in this case uses the chart the examination work clothes to examine the product again, did not consider other situation has two kind of possibilities according to the theoretical calculation four hole pitch of hol

As the 22.5mm PIN to test a single hole, minimum aperture is 22.6mm, in this case and then use figure test tool to test the product, does not consider a different situation based on theory of four-hole pitch tolerance there are two possibilities: ① hole diameter for 22.6mm, four holes the hole dista

正在翻译，请等待...