求翻译：刀座在成型时会造成难于控制的收缩缺陷,以至于难于保证每个刀座孔径完全一致.所以我司有增加一道工序用绞刀对刀座孔径进行100%尺寸矫正.是什么意思？

The knife block will result in the molding shrinkage defects are difficult to control, so it is difficult to ensure that each knife aperture completely, so I increase a process 100% reamer tool holder aperture size correction.

Molding knife will make it difficult to control when the systolic defect, to the extent that it was difficult to ensure that each knife is a aperture is fully consistent with division, so I added a bit of work with the aperture in the knife size correction 100 % .

Tool apron when formation can create the contraction flaw which difficulty with controls, difficulty with guaranteed each tool apron aperture is completely consistent. Therefore I take charge of have increase a working procedure to carry on 100% size correction with the reamer to the tool apron aper

Knife block molding shrinkage defects that would create a difficult to control when, so it is difficult to guarantee that every knife block aperture exactly. so we have to increase operation reamers to 100% knife block aperture size correction.

正在翻译，请等待...