求翻译：通常调压绕组的匝数较少，因此R11、L11很小，在改变变压器分接头进行调压换挡时稳态的冲击电流很小。但当晶闸管控制不当，导致图1中的开关K在调压换挡时分接头间的绕组构成闭合回路时，则会产生一个很大的冲击电流：是什么意思？

Regulating winding turns is usually small, so the R11, L11 is small, changing the transformer tap for regulating the impact of the shift when the steady-state current is very small. But when the thyristor controlled, leading to the switch in Figure 1 K shift in the voltage regulator connector hours

正在翻译，请等待...

The usual accent presses the winding the number of windings to be few, therefore R11, L11 are very small, carries on when the change transformer tapping adjusts the pressure shifts gears the stable state surge current to be very small.But when the thyristor controls improper, when causes Figure 1 sw

Usually fewer turns of the voltage windings, R11, L11 is very small, in changing transformer tap tap shift steady-state current is very small. When thyristor control incorrectly, resulting in Figure 1 switch k voltage shift of time winding form when closed circuit between the connector, you will hav

正在翻译，请等待...