当前位置:首页 » 翻译 
  • 匿名
关注:1 2013-05-23 12:21

求翻译:在R-L负载下,通过无触点开关在变压器的两个分接头之间切换,每40ms改变一次分接头,此时通过计算机仿真输出的电压电流波形如图2所示,其中红色为电压波形,黑色为电流波形。是什么意思?

待解决 悬赏分:1 - 离问题结束还有
在R-L负载下,通过无触点开关在变压器的两个分接头之间切换,每40ms改变一次分接头,此时通过计算机仿真输出的电压电流波形如图2所示,其中红色为电压波形,黑色为电流波形。
问题补充:

  • 匿名
2013-05-23 12:21:38
In the RL load, through non-contact switch in the transformer tap switch between the two, every 40ms to change a tap, this time by the computer simulation output voltage and current waveforms shown in Figure 2, where the red for the voltage waveform, black for the current waveform.
  • 匿名
2013-05-23 12:23:18
-L R under load, and the adoption of contactless switch in transformer switch between two sub-connector, for every 40 Ms change through a sub-connectors, at this point in time the computer simulation output voltage current waveform as shown in figure 2, in which red-voltage waveform, black-current w
  • 匿名
2013-05-23 12:24:58
Under the R-L load, cuts through the non-contact switch between the transformer two tapping, each 40ms changes one time the tapping, this time through computer simulation output voltage current waveform as shown in Figure 2, in which red is the voltage waveform, the black for the current waveform.
  • 匿名
2013-05-23 12:26:38
R-L load, by contactless switch two transformer tap switch between tap every 40ms changed, this time by computer simulation of output voltage and current waveforms such as shown in Figure 2, where red is the voltage waveform, black as the current waveform.
  • 匿名
2013-05-23 12:28:18
正在翻译,请等待...
 
 
网站首页

湖北省互联网违法和不良信息举报平台 | 网上有害信息举报专区 | 电信诈骗举报专区 | 涉历史虚无主义有害信息举报专区 | 涉企侵权举报专区

 
关 闭