求翻译：我们用SV100的接口可以供给他们配的阀24v,但是我们的气路是常开的.msi工程师还是想用dv8000的设置,这样气路也可以是受控的,dv8000 pin1 and pin2可以驱动他们的马达,但是每开一次会有相应的报警(如下图).其实他们可以直接把气路接在他们的控制器上,这样问题全部都解决了(因为另外的部门我已经这样做了),不知道为什么他们不愿意尝试?现在他们还是一致坚持要用dv8000控制开关阀信号和气压信号.是什么意思？

We use the SV100 can supply them with the interface valve 24v, but our gas is normally open. Msi engineers want to use the dv8000 or the setting, so gas can also be controlled, dv8000 pin1 and pin2 can drive their motor, but each one will open the corresponding alarm (see below). In fact, they can b

正在翻译，请等待...

正在翻译，请等待...

正在翻译，请等待...

We use the SV100 can supply them with the interface valve 24v, but our gas is normally open. Msi engineers want to use the dv8000 or the setting, so gas can also be controlled, dv8000 pin1 and pin2 can drive their motor, but each one will open the corresponding alarm (see below). In fact, they can b