求翻译：1、用已知碳硫含量的定量（一般为1克）钢铁标样放入燃烧炉，按上述 “分析操作”步骤操作，待吸收灯刚灭时，分别调整C、S校准旋钮，使表头读数与标样C、S含量值相同。是什么意思？

1, with known carbon and sulfur content of the quantitative (usually 1 gram) steel standard sample into the furnace, according to the above "analysis operation" steps, until the absorption of light just off, respectively, to adjust C, S calibration knob so that the table the first reading and the st

1, a known carbon content of sulfur the quantitative (usually between 1 grams) placed in iron and steel standard sample stoves, according to the above "analysis" steps, to be absorbed operation lamp just fight, respectively, S C calibration adjustment knobs, make the standard sample table first read

1st, (was generally 1 gram) the steel and iron standard sample puts in the combustion furnace with the known carbon sulfur content quota, according to above “analysis operation” step operation, treats absorbs when the lamp just extinguished, separately adjusts C, the S calibration knob, caused a tab

1, with a known carbon-sulfur content of quantitative (usually a 1 g) steel standard sample into a burning furnace, according to the above "parse operation" steps, when absorbed light first fight, adjusting calibration knob c, s, respectively so that the table head reading and standard sample conten

1 quantitative, using known carbon-sulfur content (typically 1 g) combustion furnace steel standard sample into the above-mentioned "profiling" steps, when absorbed light first fight, adjust c respectively, s calibration knob, header reading and sample c, s content the same.