|
关注:1
2013-05-23 12:21
求翻译:由图8可见,系统输出电流谐波总畸变率(Total Harmonic Distortion,THD)基本能够满足小于5%的分布式电源并网要求。但是由于LC滤波参数是在满负荷条件下计算得到,因此在低负荷时的滤波效果较差。而且PI控制在高负荷时产生的直流电压波动会显著影响到输出的谐波含量。是什么意思? 待解决
悬赏分:1
- 离问题结束还有
由图8可见,系统输出电流谐波总畸变率(Total Harmonic Distortion,THD)基本能够满足小于5%的分布式电源并网要求。但是由于LC滤波参数是在满负荷条件下计算得到,因此在低负荷时的滤波效果较差。而且PI控制在高负荷时产生的直流电压波动会显著影响到输出的谐波含量。
问题补充: |
|
2013-05-23 12:21:38
Figure 8 shows the system output current total harmonic distortion ratio (Total Harmonic Distortion, THD) less than 5% can basically meet the requirements of distributed power grid. However, due to LC filter parameters are calculated under full load conditions, so the low-load filtering less effecti
|
|
2013-05-23 12:23:18
正在翻译,请等待...
|
|
2013-05-23 12:24:58
As seen in Figure 8, the system output current overtone total distortion factor (Total Harmonic Distortion, THD) basic can be smaller than satisfiedly 5% distributional power source incorporation request.But because the LC filter parameter is the computation obtains under the full load condition, th
|
|
2013-05-23 12:26:38
Figure 8 shows that total system output current harmonic distortion rate (Total Harmonic Distortion,THD) distributed grid-connected power requirement basic to meet less than 5%. But because LC filter parameters are under full load condition calculated, so the filter effect at low load time is worse.
|
|
2013-05-23 12:28:18
Figure 8 shows that total system output current harmonic distortion rate (Total Harmonic Distortion,THD) distributed grid-connected power requirement basic to meet less than 5%. But because LC filter parameters are under full load condition calculated, so the filter effect at low load time is worse.
|
湖北省互联网违法和不良信息举报平台 | 网上有害信息举报专区 | 电信诈骗举报专区 | 涉历史虚无主义有害信息举报专区 | 涉企侵权举报专区