求翻译：执行换单后，重新测量所有刀线轮的实际位置值，计算所有刀线的误差值，如实际值大于设定值，请将次刀线的零点偏移值加上次刀线的实际值与设定值的误差值是什么意思？

For a single re-measuring the value of the actual position of the wheel of knife line, calculate the error value of all knife line, such as the actual value is greater than the set value, please send your knife line zero offset value plus the actual knife line value setting error value

After the switch, re-measure all knife wire wheel the actual position values, and computing all the error value, such as Actual Values greater than the set value, the knife will be the zero offset value plus time value the actual knife set to the error value value

正在翻译，请等待...

After you perform a single, again measuring actual position value for all round knife line, calculate the error values for all knife line, such as actual value is greater than the set value, secondary knife line of zero offset value plus knife line of practical value and set the value of error value

正在翻译，请等待...