求翻译：剪一段长为10cm左右的1.5mm2黄绿色接地线，一头压上OTJ 2.5-6的裸铜端子，然后把接地线固定在二极管的头部，中间要加上两个齿形垫圈，用M6螺母拧紧。然后在二极管的另一端套一根细的热缩管，用热吹风枪吹好，再在外面套一段外径加大的热缩管，可以把二极管完全罩住，也用热风枪吹好缩紧。是什么意思？

Cut a long 1.5mm2 yellow-green ground wire of about 10cm, a pressure on the otj 2.5-6 bare copper terminal, then the ground wire is fixed to the head of the diode, in the middle to add two toothed washers, m6 nut tighten. Diode the other end of a thin heat-shrinkable tube, blowing hot hair gun, outs

To cut a long period of about 10 CM 1.5 mm 2 yellow-green ground wire, and a head pressure OTJ 2.5 - 6 on the bare copper terminals, and then the ground wire to the 2 pole tube in the head, the middle and two tooth washer, tighten the nut with M 6. And then in the 2-pole the other end of the hose in

Cuts a section chief is about 10cm 1.5mm2 Huang Lvse meets the grounding, presses the OTJ 2.5-6 bare copper posts, then meets the grounding to fix in the diode forehead, middle must add on two tooth profile gaskets, screws tight with the M6 nut.Then in a diode another cable muff thin pyrocondensatio

Cut a long for about 10cm 1.5mm2, yellow-green grounding wire, one of pressure OTJ 2.5-6 bare copper Terminal, and then attach the ground wire to the diode in the head, in the middle with two toothed washers, M6 nuts tighten. And then at the other end of the diode sets of heat shrinkable tubing of a

正在翻译，请等待...