求翻译：端模用6mm厚以上钢板制成，上下分为两块，相互间采用栓接，端模形状可直接固定锚垫板同时预留穿波纹管用的孔。端模制作时必须保证锚垫板端面与钢绞线方向垂直。是什么意思？

Client mode with 6mm thick steel plate over, and down into two, with each other using bolted, side mold shape can also be reserved directly through the fixed anchor plate corrugated tubes of the hole. End module production must ensure that the anchor plate end and strand perpendicular.

Port model for more than 6 mm thick steel plate, the upper and lower are divided into two pieces made from each other, using bolted, port model shapes can be directly fixed anchor pad wear corrugated pipes also reserved the hole. You must ensure that Anchor pad model when the production end face and

The end mold makes with the 6mm thick above steel plate, about divides into two, uses the bolting mutually, carries the mold shape to be possible the direct mooring anchor backing strip simultaneously to reserve puts on the hole which the ripple is effective.The end mold manufactures when must guara

-End model with 6mm made of thick steel plate above, divided into two blocks that interact to bolt, port mode shapes can be directly fixed anchor pad at the same time set aside to wear holes used in corrugated tube. End model must remain the anchor pad end perpendicular to the surface and steel stra

Client mode with 6mm thick steel plate over, and down into two, with each other using bolted, side mold shape can also be reserved directly through the fixed anchor plate corrugated tubes of the hole. End module production must ensure that the anchor plate end and strand perpendicular.