|
关注：1
2013-05-23 12:21
求翻译：原因铜线上锡后过粗，上锡后铜线、红黑线的直径需在0.8±0.1mm、黄线0.6±0.1mm（PCBA大孔：1.1mm, PCBA小孔0.8mm）是什么意思？ 待解决
 悬赏分：1
- 离问题结束还有
原因铜线上锡后过粗，上锡后铜线、红黑线的直径需在0.8±0.1mm、黄线0.6±0.1mm（PCBA大孔：1.1mm, PCBA小孔0.8mm）
问题补充： |
|
2013-05-23 12:21:38
Reasons for copper on the tin is too thick, the diameter of the copper wire, red and black lines on the tin required 0.8 ± 0.1mm and the yellow line 0.6 ± 0.1mm (the pcba big hole: 1.1mm, pcba holes 0.8mm)
|
|
2013-05-23 12:23:18
Why is copper, tin, tin-too thick after copper, red and black wires in the Diameter 0.8 ± 0.1 MM, 0.6 ± 0.1 mm line (PCBA large hole: 1.1 MM, 0.8 mm holes PCBA )
|
|
2013-05-23 12:24:58
In after the reason copper wire the tin excessively is thick, after on the tin the copper wire, the red heavy line diameter must in 0.8±0.1mm, the yellow line 0.6±0.1mm (the PCBA pocket: 1.1mm, PCBA eyelet 0.8mm)
|
|
2013-05-23 12:26:38
Cause after Tin on copper wire is too coarse, after Tin on copper wire, diameter of the red and black lines be 0.8 0.6 ± 0.1mm ± 0.1mm, yellow line (PCBA big hole: 1.1mm, PCBA holes 0.8mm)
|
|
2013-05-23 12:28:18
正在翻译，请等待...
|
湖北省互联网违法和不良信息举报平台 | 网上有害信息举报专区 | 电信诈骗举报专区 | 涉历史虚无主义有害信息举报专区 | 涉企侵权举报专区
